Motor driver
OSEPP
Web N°: 37-0209
$29.95
Motor driver
OSEPP
Web N°: 37-0209
$29.95
Description
Motor driver can drive a 4 wire stepper motor, or two DC motors simultaneously for your Arduino project. Ability to control motor direction and speed when used with an Arduino.
- 100% Arduino compatible
- L298 dual h bridge driver
- Reverse motor polarity (motor direction)
Details and Specifications
Pin outs overview:
- ENA - Motor 1 (out 1, 2) Enable line
- IN1 - Motor 1 (out 1, 2) IN1 control line
- IN2 - Motor 1 (out 1, 2) IN2 control line
- ENB - Motor 2 (out 3, 4) Enable line
- IN3 - Motor 2 (out 3, 4) IN1 control line
- IN4 - Motor 2 (out 3, 4) IN2 control line
- OUT1 - Motor 1 driver output1
- OUT2 - Motor1 driver output2
- OUT3 - Motor2 driver output1
- OUT4 - Motor2 driver output2
- +12V - Motor supply (6 to 35V)
- +5V - **Logic supply
- GND - Ground
** The driver comes with a 5V linear regulator supply. The 5V supply is enabled with a jumper. If your motor supply is higher than 12V it's recommended that you remove the jumper and use an external supply. The 5V supply is enabled with a Jumper.
